Wifi-issue with Intel AX210
Posted: Thu Nov 28, 2024 9:00 pm
Hi folks,
I wondered if anyone has a solution for my wifi issue: I installed the Synocon Wifi Module (M2 Key E on the Asrock J5040 Mainboard) and can't get it up and running in COS. All other OSes (Mint, Win11) work fine with that card.
Funfact: In COS the bluetooth part of the card works.
inxi gives the hint that the driver is missing. modprobe iwlwifi doesn't give any output. Since I have little experience with debian any help is appreciated.
Thanks in advance.
Ixel
*** inxi output ***
Network:
Device-1: Intel Wi-Fi 6 AX210/AX211/AX411 160MHz driver: N/A
modules: iwlwifi port: f040 bus-ID: 02:00.0 chip-ID: 8086:2725
class-ID: 0280
Device-2: Realtek RTL8111/8168/8411 PCI Express Gigabit Ethernet
vendor: ASRock driver: r8169 v: kernel port: e000 bus-ID: 03:00.0
chip-ID: 10ec:8168 class-ID: 0200
IF: eth0 state: up speed: 100 Mbps duplex: full mac: <filter>
Bluetooth:
Device-1: Intel type: USB driver: btusb v: 0.8 bus-ID: 1-8:4
chip-ID: 8087:0032 class-ID: e001
Report: hciconfig ID: hci0 rfk-id: 0 state: up address: <filter> bt-v: 3.0
lmp-v: 5.2 sub-v: 3756 hci-v: 5.2 rev: 3756
Info: acl-mtu: 1021:4 sco-mtu: 96:6 link-policy: rswitch sniff
link-mode: slave accept
service-classes: rendering, capturing, object transfer, audio
I wondered if anyone has a solution for my wifi issue: I installed the Synocon Wifi Module (M2 Key E on the Asrock J5040 Mainboard) and can't get it up and running in COS. All other OSes (Mint, Win11) work fine with that card.
Funfact: In COS the bluetooth part of the card works.
inxi gives the hint that the driver is missing. modprobe iwlwifi doesn't give any output. Since I have little experience with debian any help is appreciated.
Thanks in advance.
Ixel
*** inxi output ***
Network:
Device-1: Intel Wi-Fi 6 AX210/AX211/AX411 160MHz driver: N/A
modules: iwlwifi port: f040 bus-ID: 02:00.0 chip-ID: 8086:2725
class-ID: 0280
Device-2: Realtek RTL8111/8168/8411 PCI Express Gigabit Ethernet
vendor: ASRock driver: r8169 v: kernel port: e000 bus-ID: 03:00.0
chip-ID: 10ec:8168 class-ID: 0200
IF: eth0 state: up speed: 100 Mbps duplex: full mac: <filter>
Bluetooth:
Device-1: Intel type: USB driver: btusb v: 0.8 bus-ID: 1-8:4
chip-ID: 8087:0032 class-ID: e001
Report: hciconfig ID: hci0 rfk-id: 0 state: up address: <filter> bt-v: 3.0
lmp-v: 5.2 sub-v: 3756 hci-v: 5.2 rev: 3756
Info: acl-mtu: 1021:4 sco-mtu: 96:6 link-policy: rswitch sniff
link-mode: slave accept
service-classes: rendering, capturing, object transfer, audio