USB Booter getting stuck?
Posted: Fri Oct 25, 2024 10:21 pm
I created a Boot USB using RUFUS. Plugged it into my lil acemagic box.
ADLER LAKE iNTEL 12TH GEN 16GB RAM
Initial boot seemed fine, but then I get to:
INIT: version 2.96 booting
Using makefule-style concurrent boot in runlevel S.
Starting hotplug events dispatcher: systemd-udev.
Synthesizing the initial hotplug events (susbsytems)...done.
Synthesizing the initial hotplug events (devices)...done.
Waiting for /dev to be fully populated...
ANd thats where it sits. Occasionally I see the usb light flash. I have no idea if its stalled or actually doing anything. I waited about 30min first go around and then rebooted. Starting over. Will let this run and see what happens.
When I tried installing the iso on a Virtualbox everything was fine until the last 94% of the install and then I get an error and about grub and to reboot. So, dutifully I did and the VM won't boot. I am going to try and start fresh with the VB while the lil pc sits there hopefully doing it's thing.
Cheers
ADLER LAKE iNTEL 12TH GEN 16GB RAM
Initial boot seemed fine, but then I get to:
INIT: version 2.96 booting
Using makefule-style concurrent boot in runlevel S.
Starting hotplug events dispatcher: systemd-udev.
Synthesizing the initial hotplug events (susbsytems)...done.
Synthesizing the initial hotplug events (devices)...done.
Waiting for /dev to be fully populated...
ANd thats where it sits. Occasionally I see the usb light flash. I have no idea if its stalled or actually doing anything. I waited about 30min first go around and then rebooted. Starting over. Will let this run and see what happens.
When I tried installing the iso on a Virtualbox everything was fine until the last 94% of the install and then I get an error and about grub and to reboot. So, dutifully I did and the VM won't boot. I am going to try and start fresh with the VB while the lil pc sits there hopefully doing it's thing.
Cheers